Service manual

CONTROL OPERATION & PROGRAMMING SUMMARY
MODE OPERATION RESULT/RESPONSE
SPACE TO SALES
TO DISPLAY CURRENT COLUMN TO SELECTION CONNECTIONS:
“SSS”
Press and release any
selection
Displays current column(s) connected to that selection
(Press Mode Switch
Six Times)
TO CONNECT AND DISCONNECT COLUMNS FOR A SELECTION:
Press and release the
selection to be changed.
Then press and hold same
selection again for 3
seconds
Display shows “CO 1” (Column 1). Displayed column number may or may
not flash.
Flashing = Column is connected to the selection
Continuous = Column is not connected to the selection
Selection Buttons 1,2, 3 and 4 are now used as programming buttons
to connect and disconnect columns.
Press (Selection) Switch 1 Increases displayed column number
Press (Selection) Switch 2 Decreases displayed column number
Press (Selection) Switch 3 Changes connection status of displayed
column number
Press (Selection) Switch 4 Records and ends connection changes
for the selection. Display returns to SSS
beginning.
Buttons 1,2,3 and 4 are used as selection switches again.
After connection changes are made and door is closed, the new settings will be displayed.