Instruction Manual

Hardware Installation DeviceMaster 500 User Guide: 2000501 Rev. A - 11
Hardware Installation
Note: Align the power plugs properly. The scalloped side of the screw terminal
power connector should be aligned with the scalloped side of the power
jack on the unit.
6. Verify that the Status LED has completed the boot cycle and network
connection for the DeviceMaster 500 is functioning properly using the table
below.
7. Go to Initial Configuration
on Page 19 for default network settings and how to
configure the DeviceMaster 500 for use.
LED Descriptions
Status
The amber Status LED on the device is lit, indicating you
have power and it has completed the boot cycle.
Note: The Status LED flashes while booting and it takes
approximately 15 seconds for the Bootloader to
complete the cycle. When the Bootloader completes the
cycle, the LED has a solid, steady light that blinks
approximately every 30 seconds.
Link Act
If the red Link Act LED is lit, it indicates a working Ethernet
connection.
Duplex If the red Duplex LED is lit, it indicates full-duplex activity.
100
If the red 100 LED is lit, it indicates a working 100 MB
Ethernet connection (100 MB network, only). If the LED is
not lit, it indicates a 10 MB Ethernet connection.