LA Controller Product Data Sheet Linear Actuator Controller Standard Features: 3 user programmable actuator travel set points 12 VDC (nominal) 7.5 Amp fuse Control box and wired 3-button switch: No IP rating (not waterproof) Concentric International 1901 Bell Ave., Suite 18, Des Moines, IA 50315 www.concentricintl.com Rev.
LA Controller Each Kit Contains the Following Components: (1) Control Unit (1) Control unit wire harness (1) W ired 3-button switch (1) 3-button switch wire harness (1) Double-sided tape (1) Mounting hardware Optional Accessories: o 10’ Linear actuator cable extension harness (part no: LA-EXTHARN) o Linear actuators 2”, 4”, 6”, 8”, 10”, 12” (actuator must have a potentiometer) Explanation / Overview: This unit features 3 user defined presets that are easily programmed via the wired 3butto
LA Controller 4. Press and hold the number 1 button for 5 seconds. a. The LED will flash to indicate the setting has been learned and stored. 5 seconds 5. Position the actuator extension tube to where you would like Preset #2 to be located. OR 6. Press and hold the number 2 button for 5 seconds. a. The LED will flash to indicate the setting has been learned and stored. 5 seconds 7. Position the actuator extension tube to where you would like Preset #3 to be located. OR 8.
LA Controller Dimension Diagram: Concentric International 1901 Bell Ave., Suite 18, Des Moines, IA 50315 www.concentricintl.com Rev.
LA Controller Wiring Diagrams: LA-CONTROLLER DIP Switches 1&2 Concentric International 1901 Bell Ave., Suite 18, Des Moines, IA 50315 www.concentricintl.com Rev.
LA Controller LA-CONTROLLER with Optional Momentary Push Buttons Concentric International 1901 Bell Ave., Suite 18, Des Moines, IA 50315 www.concentricintl.com Rev.
LA Controller LA-CONTROLLER Wire Connections Concentric International 1901 Bell Ave., Suite 18, Des Moines, IA 50315 www.concentricintl.com Rev.
LA Controller Mounting: The control unit and the wired 3 -button switch must be mounted out of the weather to avoid moisture (they are not waterproof). The wired 3-button switch can be mounted in a variety of ways. Below you will find some mounting options. Use the supplied double-sided tape to mount the switch to any flat surface. Use the supplied mounting bolts and support bracket for a more secure mounting option.
LA Controller DIP Switch Settings: After changing DIP switch settings, you must cycle the power to the LA -Controller for the change to take effect. DIP Switch #1 OFF DIP Switch #2 OFF (switch position up) (switch position up) W ith power applied to the LA-Controller – with or without power applied to the YELLOW ignition wire: All buttons on the wired 3-button switch function normally. All 3 wires for the optional push button input switches function normally.
LA Controller DIP Switch #1 ON DIP Switch #2 ON (switch position down) (switch position down) W hen power is first applied to the LA-Controller – without power applied to the YELLOW ignition wire: Actuator extension stays where it is at power up. The wired 3-button switch does not work. The 3 wires for the optional push button input switches do not work. W ith power applied to the YELLOW ignition wire: Actuator extension moves to preset #2.