Instructions / Assembly

Fig. 6

Notice the half ball on the end of the support rod

is grooved down one side (see figure 6). This

Keyway fits over the small keyway pin on the

inside of the mounting bracket and keeps the

ceiling fan from spinning on the mounting

bracket.

Using your step ladder, lift the fan and place the

half ball in the center of the mounting bracket

with the keyway pin inserted into the keyway on

the ball. Turn the fan left and right slightly to

make sure it is seated on the bracket with the

keyway pin in the keyway (see figure 7).

Trim the lead wires, leaving about six inches of

each wire extending from the support rod (see

figure 8).

Step 3 Hanging the Fan Body

Mounting Bracket

Keyway Pin

Ball Hanger

Support Rod

Mounting

Bracket

Keyway Pin

Ball Hanger

Support Rod

Ground Wire

Support Rod

Ball Hanger

Fig. 7

Fig. 8