Instructions / Assembly

7
If you require or would like to
use a different method of con-
trolling your fan, refer to the
OPTIONAL ELECTRICAL
WIRING PROCEDURES on
page 11.
Step 4 Making the Electrical Connections
To operate your ceiling fan with the pull chain(s)
and switches mounted on your fan, follow the
instructions below:
Fig. 9
Fig. 10
Green
White
Black
Blue
Green
White
Black
Blue




Attach the GREEN wire (connected to the
half ball) to the GROUND
wire in the junc-
tion box. The GROUND wire is usually a
bare copper wire without plastic insulation. It
could also be covered in green plastic insula-
tion (see figure 9).
Attach the BLACK wire and the BLUE
wire
from the ceiling fan to the BLACK wire in
the junction box.
Attach the WHITE wire from the fan to the
WHITE
wire in the junction box.
Fold the connected wires (see figure 10) and
push them up inside the electrical junction
box with the black and blue wires to one side
and the white and green to the other side.
Make sure the wire nuts do not come loose
during this operation.
Each of the above connec-
tions should be made as tight
as possible using the proper
size plastic wire nuts. Plastic
electrical tape is not recom-
mended for these connec-
tions.