Instructions / Assembly

8



Slide the ceiling canopy up into place over
the ceiling mounting bracket. The two
screws on the mounting bracket face should
slip through the key hole slots in the canopy
(see figure 11).
Rotate the canopy slightly until the screw
heads are in the small end of the key hole.
Tighten both screws.
Step 5 Attaching the Ceiling Canopy,
Canopy Gasket Installation.
Fig. 11
Support Rod
Canopy
Canopy
Screws
Fig. 12
Screw Pads
Screw Pads
Blade Arm


Attach each fan blade to a blade arm with three (3)
3/16” x 1/2” washer head screws and three (3) 3/16”
screw pads (see figure 12). DO NOT OVER
TIGHTEN THESE SCREWS.
Screws should be tightened until the screw pads
are compressed by the screw head. Hold the Blade
Arm decorative side down
and place the blade on
top with the flat side of the blade facing down.
Each screw is passed through the screw pad and
blade and screwed into the blade arm.
Depending on how deep the
electrical junction box was
installed in the ceiling, you
may have a slight gap
between the ceiling canopy
and the ceiling.
Step 6 Fan Blade and Blade Arm Assembly
Junction boxes are commonly installed at differ-
ent depths in the ceiling, so we have designed
the mounting bracket and canopy to allow for
this
Most CONCORD fans are supplied with a
reversible blade finish. Choose the blade finish
that you prefer and attach as follow: