Instructions / Assembly

9
Fig. 9
Fig. 10
Green
White
Black
Blue
Green
White
Black
Blue




Attach the GREEN wire (connected to the
half ball) to the GROUND
wire in the junc-
tion box. The GROUND wire is usually a
bare copper wire without plastic insulation. It
could also be covered in green plastic insula-
tion (see figure 9).
Attach the BLACK wire and the BLUE
wire
from the ceiling fan to the BLACK wire in
the junction box.
Attach the WHITE wire from the fan to the
WHITE
wire in the junction box.
Fold the connected wires (see figure 10) and
push them up inside the electrical junction
box with the black and blue wires to one side
and the white and green to the other side.
Make sure the wire nuts do not come loose
during this operation.



Slide the ceiling canopy up into place over
the ceiling mounting bracket. The two
screws on the mounting bracket face should
slip through the key hole slots in the canopy
(see figure 11).
Rotate the canopy slightly until the screw
heads are in the small end of the key hole.
Tighten both screws.
Step 5 Attaching the Ceiling Canopy
Each of the above connec-
tions should be made as tight
as possible using the proper
size plastic wire nuts. Plastic
electrical tape is not recom-
mended for these connec-
tions.
Fig. 11
Support Rod
Canopy
Canopy
Screws