Specification
Concrobium Mold Control
®
is an EPA-registered
solution that eliminates and prevents mold
without any harmful chemicals. The colorless,
odorless solution is used by professionals for:
> Mold clean-up during remodelling projects
> Mold and mildew treatment while painting
> Mold prevention in homes and facilities
> Musty odor control in vulnerable areas
Concrobium Mold Control dries to form an invisible
antimicrobial shield that encapsulates and physically
crushes mold spores. The antimicrobial barrier remains
on surfaces to provide continuous protection against
mold growth.
Recommended Uses
Concrobium Mold Control can be used in homes,
businesses, institutions, cottages, RVs, boats – anywhere
that mold takes hold.
Construction and renovation – pre-treatment of building
materials (e.g. drywall, lumber) for mold prevention;
elimination of mold found during renovation
Specialty mold clean-up and prevention – Cars, RVs,
boats, sporting equipment
Safe for use on virtually any surface (finished and
unfinished): drywall, lumber, plaster, concrete, siding,
shingles, composite decking, metal, marble, tile, grout,
fabric, upholstery, furniture, clothing.
Safe for use on hard surfaces and fabrics.
Application Guidelines
Application – For best results, apply a thin, even coating
of Concrobium Mold Control to the surface, and allow
to dry thoroughly. Once dry, use product to clean any
residual staining. If staining persists, use Concrobium
Mold Stain Eraser™ to completely remove all mold
staining. Leave, thin, even coating of product on surface
to provide protection against mold.
* Note: Surfaces treated with Concrobium Mold Control
can be painted with latex-based products if required.
Application techniques – Roller, brush, rag, garden
sprayer. Can also be applied with a cold fogging machine
to treat large or inaccessible areas.
Coverage – Coverage varies according to surface and
application method.
Fogging: approximately 1,400 sq ft. per gallon
(the equivalent of a 20’ x 20’ room with 8 foot ceilings, all
surfaces).
Spray (manual or compression sprayer): 500 sq. ft. per
gallon depending on sprayer type.
Expect reduced coverage on absorbent surfaces such as
fabrics, carpet, lumber and unpainted drywall.
Special application instructions – Do not dilute.
Do not rinse. Do not use bleach-based products in
combination as this may reduce product efficacy.
Handling – No special controls, ventilation, or
personal protective equipment is required while
handling the product. To avoid applicator exposure to
mold or mold spores during use, consult product label
section: “PERSONAL PROTECTION EQUIPMENT
REQUIREMENTS FOR APPLICATORS”.
Storage – Store containers between 39°F and 100°F.
If product freezes, thaw and mix thoroughly.
Product Specication Sheet