Operating instructions

30
W415-0680 / 04.10.08
WAVE
S36WN (BROWN)
S36WP (PEWTER)
CONCAVE
S36CCN (BROWN)
S36CCP (PEWTER)
CONVEX
S36CVN (BROWN)
S36CVP (PEWTER)
OPTIONAL CLEAN FACE SURROUND INSTALLATION BCDV36CF(G) ONLY
FIGURE 85FIGURE 83 FIGURE 84
FINISHED FLOOR INSTALLATION
FIGURE 86a
HEARTH INSTALLATION
When installing to a hearth the fi replace riser must create a minimum clearance of 3 3/8" PLUS the height of the hearth from
the fi nished fl oor to the bottom of the fi replace.
FIGURE 86b
!
WARNING
Installation requires a minimum of 6 1/2" non-combustible facing material at the top of the fi replace. Refer to either
Figure 86a or Figure 86b (depending on your installation) to ensure your fi replace has been installed with the proper
requirements for this kit.
Refer to Figure 87 for installation instructions for the steel header (supplied).
Whether installing to a fi nished fl oor or a hearth, a 3/8" clearance must be maintained at the bottom of the clean face
surround kit. To obtain this clearance a fi replace riser is required.
When installing to a fi nished fl oor the fi replace riser must create a minimum clearance of 3 3/8" from the fi nished fl oor to the
bottom of the fi replace.
FINISHED
FLOOR
3
/8”
CLEARANCE
3
3
/8”
CLEANFACE SURROUND
STAND-OFF
6
1
/2” MINIMUM
37
3
/8”
FINISHED
FLOOR
CEMENT BOARD
PANEL
(SUPPLIED)
COMBUSTIBLE
MATERIAL
FIREPLACE
RISER
3
/8”
CLEARANCE
3
3
/8”
FIREPLACE
RISER
STAND-OFF
CLEAN FACE
SURROUND
KIT
CLEAN FACE SURROUND KIT
STEEL
HEADER
(SUPPLIED)
STEEL
HEADER
(SUPPLIED)
FINISHED
FLOOR
3
/8”
CLEARANCE
6
1
/2” MINIMUM
FINISHED
FLOOR
COMBUSTIBLE
MATERIAL
FIREPLACE
RISER
3
/8”
CLEARANCE
3
3
/8”
PLUS
HEARTH
HEIGHT
FIREPLAC
E
RISER
STAND-OFF
CLEAN FACE
SURROUND
KIT
HEARTH
HEARTH
3
3
/8”
PLUS
HEARTH
HEIGHT
37
3
/8”
PLUS
HEARTH
HEIGHT
STAND-OFF
CLEANFACE SURROUND
CLEAN FACE SURROUND KIT
CEMENT BOARD
PANEL
(SUPPLIED)
STEEL
HEADER
(SUPPLIED)
STEEL
HEADER
(SUPPLIED)