Operating instructions

31
W415-0680 / 04.10.08
NOTE: THE OPTIONAL CLEAN FACE TRIM KIT MUST BE INSTALLED BEFORE PROCEEDING.
1. From the rear side of the clean face surround, insert the weld studs on the top window plate
assembly upward through the holes on the underside of the top
section of the clean face surround. (FIGURE 88)
2. Using a socket wrench, secure using the nuts
and washers provided. Depending on your
surround, space may be tight. (FIGURE 88)
3. First secure the clean face surround to the
fi replace front by hooking the ledge that runs
horizontally on the rear surface of the clean
face surround over the bottom edge of the
fi replace front opening. (FIGURE 90)
4. With the clean face surround against the fi replace front, hook the
surround clips in behind the top lip of the fi replace front opening (FIGURE
90) and secure using the screws provided through the slot in the surround
clip and into the pre-drilled hole in the clean face surround. (FIGURE 90) If the optional clean face trim kit was installed, the
surround clip fi ts into the cut out and is secured in the same fashion. (FIGURE 91).
FIGURE 88
FIGURE 89
FIGURE 90
FIGURE 91
FIGURE 92
The “wave” clean face surround kit is shown in all illustrations.
OPTIONAL CLEAN FACE TRIM KIT INSTALLATION
Combustible mantel clearance can vary according to the mantel depth. Figure 94. Use the graph to help evaluate the
clearance needed. These same requirements apply to any combustibles protruding on either side of the fi replace.
BCDV42CF MINIMUM MANTEL AND ENCLOSURE CLEARANCES
Concave
Clean Face
Surround Kit
Illustrated
1
2
40
1
/4”
1
1
/2”
MAX
3
14”
MIN
STEEL HEADER INSTALLATION
FIGURE 93b
FIGURE 87a
FIGURE 87b
FIGURE 93a
* See Venting Section