Operating instructions

33
W415-0680 / 04.10.08
DOOR LATCH
DOOR BRACKET
FIGURE 101
FIGURE 101
BCDV42CF FINISHING
DOOR INSTALLATION / REMOVAL
Open the Valve Access Door. While holding the door securely, release the 4 latches
along the top of the door. Tilt the door forward and lift off of the two brackets at the bot-
tom of the door. When replacing the door, rest the door on the brackets ensuring
that lip of the brackets rest in the groove in the bottom edge of the door. Push the
door backward into place and secure with the 4 latches.
REMOVING THE VALVE ACCESS DOOR
1. The valve access door rotates on the pins attached to the side frame. Lift the valve
access door off the pins to operate the main glass door.
FIGURE 102
GLASS/DOOR REPLACEMENT
Only available as an assembly complete with frame W010-0770. Glass not available separately.
BCDV36CF(G) GLASS/DOOR REPLACEMENT
FIGURE100
1. Place the door frame face down careful not to scratch the paint.
2. Center the gasketed glass inside the door frame with the thick side of the gasket
facing up.
3. Bend the glass retainers located along the edge of the door frame over the
gasket holding the glass in place. Careful not to break the glass.
NOTCH
INSIDE LIP
S
E
E
-
T
H
R
U
W
I
N
D
O
W
BCDV42CF SIDE VIEW
DOOR TRIM
The BCDV42CF comes complete with top door trim (W715-0729).
1. Guide the arms of the trim into the slots that are slightly hidden under the facing through the opening between the top of the
door and the bottom edge of the facing as illustrated in the front view.
2. Slide the arm into the slot far enough to allow the front edge of the trim to go in behind the facing.
3. Let the bracket come forward towards the back of the facing and allow the trim to rest on the inside lip, this position will allow
the notch on the arm of the trim to fall into place on the edge of the slot.
BCDV42CF WITH TOP DOOR TRIM INSTALLED
SLOT
TRIM
FACING
DOOR
BCDV42CF FRONT VIEW
FIGURE 103a
FIGURE 103c
FIGURE 103b