Operating instructions

34
W415-0680 / 04.10.08
GRATE INSTALLATION
The grate for this fi replace has been removed for shipping purposes.
The grate must be installed before the logs are installed.
Remove the packaging from the grate and install onto the two pins as illustrated.
GRATE
PINS
FIGURE 104
LOG PLACEMENT
PHAZER
TM
logs and glowing embers, exclusive to Wolf Steel Ltd.,
provide a unique and realistic glowing effect that is different in every
installation. Take the time to carefully position the glowing embers
for a maximum glowing effect. Log colors may vary. During the
initial use of the fi replace, the colors will become more uniform as
color pigments burn in during the heat activated curing process.
1. Place the cutout in the bottom of log #1 behind the pilot assembly.
Rest the log against the back wall of the fi rebox.
2. Move the two small logs (#2 & #3) into position, lining up the
studs located on the burner with the holes on the bottom of the
logs.
3. Tear the glowing embers into pieces and place along the front
row of ports covering all of the burner area in front of the small
logs (#2 & #3). Care should be taken to shred the embers into
thin, small irregular pieces as only the exposed edges of the fi bre
hairs will glow. The ember material will only glow when exposed to
direct fl ame; however, care should be taken to not block the burner
ports. Blocked burner ports can cause an incorrect fl ame pattern,
carbon deposits and delayed ignition. PHAZER™ logs glow when
exposed to direct fl ame.
4. Place the bottom of the left crossover log (#4) onto the stud on
the left side of the log support. The top of the log should rest in the
pocket on the back log.
5. Place the bottom of the right crossover log (#5) onto the stud
on the right side of the log support. The top of the log should rest
in the pocket on the left crossover log (#4).
FIGURE 105
FIGURE 105
FIGURE 106
FIGURE 106
FIGURE 107
FIGURE 107
FIGURE 108
FIGURE 108
GLOWING EMBERS
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of the small logs (#2 &
#3). Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will
glow. The ember material will only glow when exposed to direct fl ame; however, care should be taken to not block the
burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER
TM
logs glow when
exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER
TM
logs available from your Authorized dealer.
Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner. Fine dust found in
the bottom of the bag should not be used.
Sprinkle vermiculite around the charcoal embers.
NOTE: Both charcoal embers and vermiculite are not to be placed on the burner.
CHARCOAL EMBERS
VERMICULITE
CHARCOAL LUMPS (BCDV42CF ONLY)
Place the lumps between the logs in a realistic manner taking care not to block any of the burner ports.
COMMON BCDV36CF / BCDV42CF FINISHING