Refrigerators and Freezers Operation, Installation and Instruction Manual Refrigerators and Freezers

and turn the needle to the desired temperature using your fingers. Replace the
lens cover and recheck the calibration.
DIGITAL THERMOMETER
For a digital thermometer, note how many degrees the digital display needs to be
increased or decreased. Press twice
directly on the mylar display towards the right
center using your finger. After pressing the first time, the display should read "cal"
indicating that you are in the calibration mode and after pressing the second time,
the display should read either zero or a positive number or a negative number (this
number is the point of origin for calibration). If your digital display needed to be
increased, you
Must advance the point of origin by that many degrees by pressing directly on the
mylar display towards the left top. If your digital display needed to be decreased,
you must decrease the point of origin by that many degrees by pressing directly on
the mylar display towards the left bottom. Once calibration is complete, return to
normal temperature mode by pressing once again on the mylar display towards
the right center. Now, recheck the calibration.
Example
: the digital display reads 7`c and the internal thermometer reads 4`c so,
the digital display must be increased by 3`. Press the right center of the display
twice and the number -1 is displayed (this is the point of origin and could have
been any number). Now, press the top left of the display three times to make the -
1 go to +2. Calibration is complete so press the right center of the display to return
to normal temperature mode.
- 12 -