Instructions / Assembly
Congratulations on purchasing your new CW
®
Wardrobe
Doors. Now that you have opened the package, we want
you to verify that you have all the necessary hardware
supplied with your doors.
PARTS CHECK LIST:
NO. QTY DESCRIPTION
(#1) 2 Mirrored Glass Panels
(#2) 1 Ultraglide
®
Top Channel with Felt Liner
(#3) 1 Bottom Track
(#4) 1 Wood Strip (located inside of track)
(#6) 6 #8 x 1-1/2″ PH SMS Screws:
(#7) 4 #8 x 1/2″ Truss Screws:
(#8) 2 Clear Plastic Bumpers:
(#9) 4 Concrete Nails:
(#10) 4 5 Penny Nails:
If you find that any parts are damaged or missing, refer to
the Parts Check List and IPB Drawing and contact
Contractors Wardrobe
®
’s Customer Service Department at
661-257-1177.
TOOL CHECK LIST:
You will need:
1. Phillips Screwdriver
2. Tape Measure
3. Hammer
4. Pencil
5. 3/8″ Drill Motor and 3/16″ and 1/8″ Drill Bits
6. Miter Box and Hacksaw
7. Square
8. Glass Cutter for optional Mirror Fascia
9. Four 1″ Screws and Screw Anchors
(For ceramic tile floors only. See Floor Check List #5.)
10. Adhesive (For ceramic tile floors only. See Floor Check
List #5.)
FLOOR CHECK LIST
1. Do you have carpet?
It is highly recommended that if you have carpet and do
not have a cut-out in the carpet already, you should cut
the carpet in order to install the Bottom Track (#3). We
do not recommend installing the Bottom Track (#3)
directly on top of carpet.
2. Do you have a concrete, wood floor or
ceramic tile floor?
A. If it is a concrete floor, go to 3…
B. If it is a wood floor, go to 4…
C. If it is a ceramic tile floor, go to 5…
3. If you have a concrete floor you will: Use Concrete
Nails (#9) to attach Wood Strip (#4) to floor.
4. If you have a wood floor you will: Use 5 Penny N a i l s
(#10) to attach Wood Strip (#4) to wood floor.
5. If you have a ceramic tile floor you will: Drill holes
with a 3/16″ Masonry Drill Bit. Insert Screw Anchors and
attach Wood Strip (#4) to floor with Screws. Or, you
may glue the Wood Strip (#4) down with Panel
Adhesive.
NOTE: Drill Bit, Screws, Screw Anchors and Adhesive
are not supplied.
TRACK OFFSET MEASUREMENTS FROM FACE
OF OPENING TO FRONT EDGE OF TRACK
Track Offset A B
All Ultraglide
®
Track and Channel
Concord
™
/ Silhouette
™
doors 1/2″ 1-1/2″
For Optional Mirror Fascia, add 1/4 to the Bottom Track
offset measurement.
Concord
™
/ Silhouette
™
- I3045 - 0806
3
PENCIL MARK TO
LOCATE FRONT
EDGE OF WOOD
STRIP
BOTTOM
TRACK
WOOD
STRIP
FACE OF
OPENING
Silhouette Series has different parts,
see Supplemental Sheet Page 6.
A
A
Concord/Silhouette Instructions 8/1/06 10:48 AM Page 3