Instructions / Assembly

INSTALLING THE DOORS
* Before you get started if you purchased our Silhouette
™
model it is almost the same as our Concord
™
model. Any
differences are noted with a Silhouette
™
Flag . If you
see this flag during an installation step please turn to
Supplemental Page 6 for that installation section.
Step 1 Removing Existing Wardrobe
Doors
Remove existing doors, brackets, top channel
and bottom track.
Step 2 Installing the Top Channel
A. Measure the opening at the top of the closet from
wall to wall.
B. Cut the new Ultraglide
®
Top Channel (#2) to this
dimension. When cutting the Top Channel (#2) we
r e c o m m e n d that you use a Miter Box and
Hacksaw for a straight cut. Cut one side only.
NOTE: If your closet has bumper jambs you may need to
notch your Top Channel (#2) on each end.
C. When cut to proper length, install Top Channel
(#2) up to the top front of closet opening making
sure that the front of the Top Channel (#2) is flush
with outside walls (See Figure 1). Hold up the Top
Channel (#2) in the desired position and with
your Pencil, mark where the pre-drilled holes are
in the Top Channel (#2).
Figure 1
D. Remove the Top Channel (#2) and drill holes
using 1/8″ Drill Bit where you made the pencil
marks. Now install the Top Channel (#2) in place
using six #8 x 1-1/2″ PH SMS Screws (#6).
Step 3 Installing the Bottom Track
A. Make sure that you have used the FLOOR
CHECK LIST on Page 3 to determine which floor
and installation you will use.
NOTE: If the floor board molding continues into the
c l o s e t opening, you may need to remove it so that
the Wardrobe Doors will close flush to the wall.
B. Locate Wood Strip (#4) supplied in kit and
measure inside bottom closet opening and cut to
length.
C. Find the correct offset measurement using the
O ffset Measuring Ta b l e on Page 3 (B
Measurement) for your particular installation. From
the front edge of closet opening inward, measure
using dimension from table and make a pencil
mark on wall. Do this on both walls, i.e., right and
left walls (See Figure 2).
Figure 2
D. Place front of Wood Strip (#4) up to pencil mark
on wall (See Figure 3). Do this on both sides. Now
attach Wood Strip (#4) according to your Offset
Measuring Table.
E. Cut the Bottom Track (#3) to your measurement of
the inside closet opening. Slide the Bottom Tr a c k
(#3) over Wood Strip (#4) and attach with four
#8 x 1/2″ Tr u s s Screws (#7).
Figure 3
Concord
™
/ Silhouette
™
- I3045 - 0806
PENCIL MARK
TO LOCATE
FRONTEDGE
OF WOOD
STRIP
PENCIL MARK
TO LOCATE
FRONT EDGE
OF WOOD
STRIP
4
ALIGN TOP CHANNEL
FLUSH WITH THE WALL
S
Concord/Silhouette Instructions 8/1/06 10:48 AM Page 4