Instructions / Assembly

SILHOUETTE
™
SUPPLEMENTAL PARTS LIST
#1 Tempered Glass Panels
#12 Bottom Mold (Top Mold same as Concord
™
)
#13 Concealed Wheel Assembly
Step 4 Installing the
Tempered Glass Panels
A. Make sure you have a pad or blanket to protect
the Tempered Glass Panels (#1) from scratches.
Lay Tempered Glass Panels (#1) with b a c k s i d e
up on the floor. Locate one of the Concealed
Wheel Assemblies (#13) on the bottom of a
Tempered Glass Panel (#1). With a Phillips
S c r e w d r i v e r, turn the adjusting screw to the right
to lower the roller. Do this until you have 3/4″ o f
roller showing. Adjust both Concealed Wheel
Assemblies (#13) on each Tempered Glass
Panel (#1) (This will avoid scratching the
Bottom Track (#3) when installing the panels).
B. Pick up one Tempered Glass Panel (#1)and, with
the outside of the panel facing you, tilt the top of
the Tempered Glass Panel (#1) back and slip the
Tempered Glass Panel (#1) into the back runner
of the Top Channel (#2). Next, set the bottom of
the Tempered Glass Panel (#1) into the back
runner of the Bottom Track (#3).
C . For the front Tempered Glass Panel (#1), repeat
B, but place the Tempered Glass Panel (#1) into
the front runner of the Top Channel (#2) and front
runner of the Bottom Track (#3).
Step 5 Adjusting the
Tempered Glass Panels
Slide the front Tempered Glass Panel (#1) to the
side closest to the room’s entrance door (This is
how the Wardrobe Doors will be in position to look
their best). Look at the space between the door
edge and the wall. You want the door edge and
the wall to be flush. If you see space at the top or
bottom edge of the Tempered Glass Panel (#1),
turn the adjusting screw through the hole in the
side rail on the Steel Wheel Assembly (#13) on
the lower back of the Tempered Glass Panel (#1)
nearest the wall. Turn the screw left or right until
the Tempered Glass Panel (#1) aligns flush with
the wall. Repeat for each Tempered Glass P a n e l
( # 1 ) .
6
Concord
™
/ Silhouette
™
- I3045 - 0806
S
Adjustment Screw
Adjustment
Hole
#13
#2
#1
S
Concord/Silhouette Instructions 8/1/06 10:48 AM Page 6