Instructions / Assembly

5
Figure2
 C. Find the correct offset measurement using the
Offset Measuring Table (B Measurement) for
yourparticularinstallation.Fromthefrontedgeof
closet opening inward, measure using dimension
from table and make a pencil mark on wall. Do this
onbothwalls,i.e.,rightandleftwalls(SeeFigure2).
D. Place front of Wood Strip (#4) up to pencil mark
onwall(SeeFigure3).Dothisonbothsides.Now
attach Wood Strip (#4) according to your Offset
Measuring Table.
E. Cut the Bottom Track (#3) to your measurement
of the inside closet opening. Slide the Bottom Track
(#3) over Wood Strip (#4) and attach with #8 x 1/2ʺ
Truss Screws (#6).
STEP 4 Installing the Mirrored
Glass Panels
A. Make sure you have a pad or blanket to protect the
Panelsfromscratches.LayPanelswithbackside
up on the floor. Locate one of the Steel Wheel
Assemblies (#13) on the bottom of a Panel.
With a Phillips Screwdriver, turn the adjusting
screw to the right to lower the roller. Do this until
you have 1ʺ of roller showing. Adjust both Steel
Wheel Assemblies (#13) on each Panel. (This will
avoid scratching the Bottom Track (#3) when
installing the Panels.)
Figure3
PENCIL MARK
TOLOCATE
FRONTEDGE
OFWOOD
STRIP
PENCIL MARK
TOLOCATE
FRONTEDGE
OFWOOD
STRIP
NOTE: If the floor board molding continues into the
closet opening, you may need to remove it so that
the Wardrobe Doors will close flush to the wall.
 B. Locate Wood Strip (#4) supplied in kit and
measure inside bottom closet opening and cut to
length.
already, you should cut the carpet in order to
install the Bottom Track (#3). We do not
recommend installing the Bottom Track (#3)
directly on top of carpet.
2. Do you have a concrete, wood floor or ceramic
tile floor?
A. If it is a concrete floor, go to 3…
B. If it is a wood floor, go to 4…
C. If it is a ceramic tile floor, go to 5…
3. If you have a concrete floor you will:UseConcrete
Nails (#9) to attach Wood Strip (#4) to floor.
4. If you have a wood floor you will:Use5Penny
Nails (#10) to attach Wood Strip (#4) to wood floor.
5. If you have a ceramic tile floor you will: Drill
holes with a 3/16ʺ Masonry Drill Bit. Insert Screw
Anchors and attach Wood Strip (#4) to floor with
screws. Or, you may glue the Wood Strip (#4)
down with panel Adhesive.
TRACK OFFSET MEASUREMENTS FROM FACE
OF OPENING TO FRONT EDGE OF TRACK
Track Offset A B
All Aluminum Track and Channel
Aurora
™
/Aurora
™
Plus doors 1/2ʺ 1-1/2ʺ
Serenity
™
/Tranquility
™
5/8ʺ 1-5/8ʺ
For optional Mirror Fascia, add 1/4 ʺ to the
Bottom Track offset measurement.
PENCIL MARK TO
LOCATEFRONT
EDGEOFWOOD
STRIP
BOTTOM
TRACK
WOOD
STRIP
FACEOF
OPENING
Aurora™/ Aurora Plus™/ Serenity™/ Tranquility™ - I3010 - 0115