Instructions / Assembly

CONVENIENT HEIGHT®
The Convenient Height
® product Model S two-piece toilet
Two-Piece Toilet Assembly and Installation Notes
● Assemble this product according to the two-piece toilet plumbing guide
● Install this product according to the two-piece toilet plumbing guide
● Product does not include a supply line, as the length needed varies per
installation
● Professional and licensed plumber two-piece toilet assembly and installation
required to activate product warranty
HOW TO REMOVE OLD TOILET WHEN REPLACING
STANDARD TOILET WITH THE CONVENIENT HEIGHT
®
a. Close toilet supply valve and flush tank completely. Towel or sponge remaining
water from tank and bowl. b. Disconnect and remove supply line. NOTE: If replacing
valve, first shut off main water supply; c. Remove old mounting hardware, remove
toilet and plug floor waste opening to prevent escaping sewer gases. d. Remove
closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed
CARE AND CLEANING THE CONVENIENT HEIGHT®
When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear
water and dry with a soft cloth. WARNING: Do not use in-tank cleaners. These
products can seriously corrode fittings in the tank. This damage can cause leakage
and property damage. Convenient Height Company shall not be responsible or liable
for any damage caused by the use of in-tank cleaners.
Convenient Company LLC. Website: convenientheight.com. Customer service phone: [phone]
Convenient Height product Model S Toilet Specification Sheet and Installation Guide Page: 4