Installation guide

www.cooperbussmann.com/BussmannWirelessResources
11
Cooper Bussmann BU-905U-L Wireless I/O Configuration Manual
Basic Steps for Configuring Your Unit
The basic steps for configuring your BU-905U-L are:
1. Install the BU-Config Software program on your PC.
NOTE - BU-Config can also configure other Cooper Bussmann units. For more information on other Cooper Bussmann units,
please see the product documentation.
2. Connect your BU-905U-L unit to the PC using the RS-232 serial cable.
3. Configure your BU-905U-L as required using the following steps:
Step Description For More infor
mation, See…
1. Set the system information Each module requires a: Setting the unit address
• System address – common to all modules in the same system. on page 40.
The 905U-L uses the system address to prevent “cross-talk”
between modules in different systems; and
• Unique unit address – that uniquely identifies the module
in a system.
2. Configure the individual units Lets you select the individual units, modify unit addresses and set Working with units on page 32.
the properties for each unit.
3. Compile the system Lets you check your system configuration, report any errors and Compiling the system on page 67.
generate configuration files for each unit.
4. Load the configuration Lets you transfer the configuration information to a module. Loading configuration information
information into the module into a unit on page 68.
5. Test the system Let you test the system (including all modules) to help easily
identify any problems.
We recommend you bench test the complete system before
installing a new system.
Configuration problems are easier to identify and fix when the
modules are nearby.
For more information, see the next sections.
3A1579Rev1.4