Installation guide

12
www.cooperbussmann.com/BussmannWirelessResources
Cooper Bussmann BU-905U-L Wireless I/O Configuration Manual
Hardware and Software Requirements
BU-Config requires the following minimum PC configuration:
Setting Additional Information
Operating system Windows 98 or later
Processor Pentium or greater
Memory Minimum 128 Mb
Disk Space 5Mb for BU-Config 17Mb during installation 1M (approximately) for each project
Serial Port 1 Serial port
RS232 serial cable EIA-561 (RJ45) to EIA-574 (DB9) Cooper Bussmann provided serial cable
Using the Configuration Software
NOTE: This document refers to the BU-905U-L Configuration software as BU-Config.
BU-Config lets you configure units using a configuration software program. The configuration software runs as a Windows application on a PC and
lets you:
• Create a configuration file – that contains specific information for all units in the system including BU-905U-L units;
• View and change the configuration information – as required;
• Program the configuration information – to each of the BU-905U-L modules via the RS-232 cable; and
• Load the configuration information – from each of the BU-905U-L modules via the RS-232 cable into the configuration file.
BU-Config lets you:
T
ask Description For more information, see …
Installing the configuration To configure your modules, you must install the BU-Config software. Installing the configuration
software software on page 12.
Start BU-Config Lets you work with your module to communicate and transfer Starting BU-Config on page 13.
information between the module and your PC.
Exit BU-Config Lets you close the software for communicating and transferring Exiting BU-Config on page 13.
information between the module and your PC.
Check your configuration Lets you identify the current version of software in use. Checking the current configuration
software version This information is important for contacting Cooper Bussmann software version on page 14.
if you have support issues.
For more information, see the next sections.
Installing the Configuration Software
To change the configuration of your module you must install the BU-Config software.
To install the BU-Config software:
1. Insert the CD.
2. Run the installation file.
3. The installation wizard will guide you through the installation process.
3A1579Rev1.4