Installation guide

www.cooperbussmann.com/BussmannWirelessResources
39
Cooper Bussmann BU-905U-L Wireless I/O Configuration Manual
Setting Unit Information
Every unit in a system has specific information configured for all units regardless of the type of unit. This information includes:
• Unit name – you can use this name to refer to the unit when configuring mappings from other units.
• Unit Address- unique address assigned to the unit. Some module types have two addresses (e.g., BU-905U-3 and BU-905U-4).
• Secondary address - for larger systems, the secondary address allows more than one transmit-only module to share the same unit address.
This only applies to BU-905U-K and BU-905U-L-T modules.
• Protocol Type - protocol used by the BU-905U-G modules only.
BU-Config lets you:
If you w
ant to … Description For more information, see …
Set the unit name Lets you set the unit name to one that is meaningful to you. Setting the unit name on page 39.
Set the unit address Lets you set the unit address that identifies the unit in the system Setting the unit address
on page 40.
Set the secondary address Lets you assign multiple transmit-only units to the same unit Setting the unit secondary
address and observe the secondary address assigned by BU-Config address on page 42.
For more information, see the next sections.
Setting the Unit Name
BU-Config lets you set the unit name to a name that is more meaningful to you. For example, you can initially configure a unit called
BU-905U-L-T#7 and then change the name to Pump station 14.
To set the unit name:
1. Select the unit you want to change.
3A1579Rev1.4