Installation guide

40
www.cooperbussmann.com/BussmannWirelessResources
Cooper Bussmann BU-905U-L Wireless I/O Configuration Manual
2. Enter the new unit name.
BU-Config automatically updates the unit name in the unit information and also in the unit listing at the side of the page.
Setting the Unit Address
BU-Config lets you set the unit address used by the system when sending messages to a module.
A valid unit address for the BU-905U-L module is between 1 and 127.
NOTE: You cannot use a unit address of 0.
A network can have up to 127 addresses communicating via radio (i.e., unit addresses 1 to 127).
BU-905U-L units can only communicate via radio and must always have a unit address between 1 and 127.
3A1579Rev1.4