Installation guide

50
www.cooperbussmann.com/BussmannWirelessResources
Cooper Bussmann BU-905U-L Wireless I/O Configuration Manual
Featur
e Description
To Destination The BU-905U-L-T will send the information about the inputs in a message to this module when the mapping is triggered.
NOTE: You can also select Unknown Unit if the unit has not been added to your project yet. In this case you must enter
the actual address of the module in the To Destination field, and the actual output number into the First Output Address
field.
First Output Address The BU-905U-L-T sends the data to the outputs at the destination module starting at this output in the destination
module. The outputs in the destination module are listed in order.
Via repeaters Sequence of units for forwarding the message to its final destination.
NOTE: You can either select the units from the dropdown list or enter the unit number.
NOTE: - Some module types only support mappings with one single input. These are the 905U-1, 905U-2, 905U-3 and 905U-4 modules.
- If you need to send more than one input to these modules, you must enter multiple mappings, each with a single input selected.
- If you need to use one of these modules as a repeater, you can only send mappings with a single input selected. If you need to send
large amounts of data, you should use a 905U-G module to act as a repeater.
Changing Unit Mappings
BU-Config lets you change an existing mapping.
To change unit mappings:
1. Open the project.
2. Select the unit you want to change:
3. Select Mappings.
4. Select the mapping you want to change and click Edit Mapping .
5. BU-Config shows the mapping information:
6. Change the mapping information as required. For more information, see How to configure a mapping on page 49.
7. Click OK to change the mapping or click Cancel to quit without changing the mapping.
8. The module will not use the modified mapping until you reconfigure it.
3A1579Rev1.4