Installation guide

Packing/Compressing the Database
BU-Config lets you pack (i.e., compress) the database so it takes up less space on your PC.
To pack the database:
1. Open the project.
2. Select Utilities » Database Utilities » Pack all Databases.
3. BU-Config packs all databases and shows an information message indicating the pack completed successfully:
4. Click OK to acknowledge the message.
Loading Configuration Information into a Unit
After compiling the system, you need to transfer the configuration information to a unit.
The basic steps for transferring the configuration information to the unit are:
Step Description For more information, see …
1. Connect the unit to the PC Lets you connect the unit to your PC using an RS 232 serial Connecting the unit to the PC
port so you can transfer configuration information between your on page 69.
PC and the unit.
2. Set the serial port Lets you set the serial port used when transferring information Setting the serial port on
to the unit. page 69.
3. Programming the unit Lets you load the configuration information from the PC to the unit. Programming the on page 70.
(optionally) Transfer the Lets you transfer the configuration information from the unit Transferring information from
configuration information to the PC. the module the PC on page 71.
For more information, see the next sections.
68
www.cooperbussmann.com/BussmannWirelessResources
Cooper Bussmann BU-905U-L Wireless I/O Configuration Manual
3A1579Rev1.4