User Manual

Page
22
2 Mega Pixel IP Camera User Manual
1. Select the sensor which needs to setup the alarm parameter at the “Sensor” pull down list.
2. The following setup steps are similar to Motion Detection Schedule’s. Please refer to
Motion Detection Schedule chapter for more details.
5.4.6 Alarm Out
1. Go to “Alarm configuration”Æ “Alarm output” as shown below:
2. Select alarm holding time and alarm name at the “Alarm out” and “Alarm holding time”
pull down list box respectively.
3. Press the “Save” button to save the settings.
5.5 Network Configuration
Network configuration includes eight submenus: Port, Wired, Server Configuration, IP Notify,
DDNS Config, RTSP, UPnP, Mail Setting and FTP.
5.5.1 Port
1. Go to “Network config”Æ “Port” to see the interface as shown below.
2. Input port number for IE access in the “HTTP Port” textbox.
3. Input the port number for audio & video transmission in the “Data Port” textbox.
5.5.2 Wired
1. Go to “Network Configuration”Æ “Wired” to see a tab shown below.
2. There are two options for IP setup: obtain an IP address auto by DHCP protocol and use the
following IP address. You may choose one of options as required.
3. Use the following IP address: display the IP address, subnet mask, gateway and DNS of the