Service manual

Ice Maker Service Manual
Publication Number: 630460082SER - 7 - © 2004-2014, Cornelius Inc.
Semi-Annually
Semi-annually, in addition to all previously established service procedures, perform the following:
1. Check for water leaks; tube connections, water fittings, and the lower icemaker water seal.
2. Check the drain tubes for clogs and ”aged” tubes. Replace if tubes are stained or brittle.
Figure 2. Auger Assembly
3.
Check for signs of condensation. Clean where necessary and replace insulation properly.
4. Check safety circuits for proper operation.
5. Check refrigeration system (see REFRIGERATION SYSTEMS section of this manual).
6. Check Unit for abnormal noise. Tighten machine and cabinet screws, if necessary.
7. Check white upper bearings on auger assembly (see Figure 2). If bearing are less than 1/16-inch thick, replace
the bearings.