Service manual

Ice Maker Service Manual

SAFETY PRECAUTIONS

This unit has been specifically designed to provide protection against personal injury. To ensure continued protection

observe the following:

WARNING:

Disconnect power to the unit before servicing following all lock out/tag out procedures established by the user. Verify

all of the power is off to the unit before any work is performed.

Failure to disconnect the power could result in serious injury, death or equipment damage.

CAUTION:

Always be sure to keep area around the unit clean and free of clutter. Failure to keep this area clean may result in

injury or equipment damage.

SHIPPING AND STORAGE

CAUTION:

Before shipping, storing, or relocating the unit, the unit must be sanitized and all sanitizing solution must be drained

from the system. A freezing ambient environment will cause residual sanitizing solution or water remaining inside the

unit to freeze resulting in damage to internal components.

CAUTION:

Very high discharges pressure is present in system. Quick disconnects on your gages will minimize danger and loss

of refrigerant.

CAUTION:

Unit requires separate electrical line. See instruction manual for proper fuse size.

WARNING:

There must be adequate clearance around ice maker. Allow minimum 6” air intake and 4” air exhaust for air

exhaust and panel removal.

NOTE: Unit must be installed per local plumbing and electrical codes. See Installation manual for

unit requirements. Failure to do so may cause damage to unit, which would void unit warranty.

NOTE: Using any parts other than genuine factory manufactured parts relieves the manufacturer

of all liability.

NOTE: Manufacturer reserves the right to change specifications at any time.