Installation & Assembly

ManualsBrandsCorrigan Studio ManualsFurnitureDrumawillin Dining Chair

Label Picture Description QTY

A Backrest 1

B Seat 1

Caution : You must read this before you proceed

CHAIR

WARNING: These Chairs are intended only for normal use with all four Chair legs on

the ground.These Chairs have relatively thin legs and are not designed to be sat in

with only two legs on the ground(as from tipping back, forward, or to the side), as such

usage can cause stress and failure of one or more Chair legs. Any misuse of the

Chairs voids any warranties, expressed or implied.

Page 1 OF 6

Summary of content (6 pages)

PAGE 1
Caution : You must read this before you proceed CHAIR WARNING: These Chairs are intended only for normal use with all four Chair legs on the ground.These Chairs have relatively thin legs and are not designed to be sat in with only two legs on the ground(as from tipping back, forward, or to the side), as such usage can cause stress and failure of one or more Chair legs. Any misuse of the Chairs voids any warranties, expressed or implied.
PAGE 2
C Front Leg 2 Description QTY ① Bolt (M6 x 35mm) 3 ② Bolt (M6 x 60mm) 5 ③ Bolt (M6 x 90mm) 5 ④ Spring Washer 11 ⑤ Washer 11 ⑥ Allen Key 1 Label Picture Before Beginning Assembly: Page 2 OF 6
PAGE 3
Overview Backrest(A) Seat(B) Front Leg(C) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 1.1) Align the Seat(B) with Backrest(A) as shown above. 1.
PAGE 4
Step 2 Attach Front Legs(C) to Seat(B) using Bolts(②), Spring Washers(④), and Washers(⑤) with Allen Key(⑥) as pictured above. Do not fully tighten the Bolts. Step 3 Place the Chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the Chair some 30cm to 50cm high from the ground. Keep your feet and toes well away from the drop zone. Drop the Chair freely and vertically with the four legs, hitting the ground, at the same time.
PAGE 5
Step 4 Inspect and make sure all parts are connected. Your Chair is ready for use. This Chair can only be used on a flat, level surface.
PAGE 6
Care & Maintenance Page 6 OF 6