User Manual

Adding an LED to a group and linking to properties
You can add LEDs to device groups and then link the colors to trigger events within the group, for example, if a
certain temperature goes too high, you can have the LEDs change color to signify that.
You can manually select colors by simply selecting the appropriate “strength” of the RGB (Red, Green, and Blue)
channels. Full blue is shown below.
Or, if you want to have the LED change colors based on temp, select the LED you want to control, and then add it to
a group using the drop down menu.
Select the “trigger” temperatures for the LED in that temperture zone, then select a color for each trigger
temperature right underneath. The LED will then automatically fade from one color to the next as it crosses over the
zones. In the image below, if the temperature is at 30C, it will be a dark blue, and at 45C it’ll be a greenish yellow.
This is not a hard and fast transition, but gradual, so between 30C and 45C, the colors eventually shift to the target
color.