Owner Manual
21 22
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death or serious burns
to children and adults.
IMPORTANT:
•
An anti-tip bracket is provided with the range. The anti-tip bracket uses a rear
range foot to secure the range to the oor or wall.
•
Attach the anti-tip bracket to the oor or wall so that the rear range foot will be
centered within the bracket when the range is pushed into its nal position.
1. Remove the anti-tip bracket and two screws (provided) from the parts bag.
a
b
a 16 x 1⁵⁄₈" Screws (2)
b Anti-tip Bracket
NOTE: The anti-tip bracket must be securely mounted to the suboor or wall. The
ooring’s thickness may require longer screws to anchor bracket to suboor.
2. Place the bracket so that the back of the bracket is against the rear wall and the
side edge of the bracket is ³⁄₈" to ¹⁄₂" from the adjacent cabinet.
NOTE: If there is no adjacent cabinet, place the bracket so that the edge of the
brack
et is ³⁄₈" to ¹⁄₂" in from the range side panel. If the countertop overhangs the
cabinet, oset the bracket from the cabinet by the depth of the overhang plus
an additional ³⁄₈" to ¹⁄₂".
3. Using the anti-tip bracket as a template, mark the two holes for either a Floor
Wood, Floor Concrete, or Wall installation, as shown.
a
b
c
d
e
a Distance from
Adjacent Cabinet (³⁄₈"
to ¹⁄₂" [0.95 to 1.27 cm])
b Wall Holes
c Concrete Floor Holes
d Wood Floor Holes
e Rear Range Foot
4. Drill two pilot holes where marked. Follow the instructions specic to your
construction.
NOTE: A nail or awl may be used to create a pilot hole, if a drill is not available.
For concrete construction ¹⁄₄" x 1¹⁄₂" Lag Bolts and ¹⁄₂" O.D. Sleeve Anchors are
required.
Wood
•
Floor - Drill a ¹⁄₈" pilot hole, as shown.
NOTE: Contact a qualied oor covering installer for the best procedure for
drilling mounting holes through your type of oor covering.
•
Wall - Drill an angled ¹⁄₈" pilot hole, as shown.
Concrete
•
Drill the size hole recommended for the anchors into the concrete at the
center of the holes identied as Floor Concrete or Wall.
a
b
c
a Wall
b Anti-tip
Bracket
c Floor
5. Install the anti-tip bracket.
Wood
•
Using the two screws (provided) fasten the anti-tip bracket to the oor or
wall.
NOTE: The screw must enter wood or metal.
Concrete
•
Insert the sleeve anchor into the drilled holes and then insert the lag bolts
through the anti-tip bracket and into the oor or wall. The bolts must be
properly tightened as recommended for the hardware.
6. Complete the range installation following the Installation Instructions
(provided).
INSTALL ANTI-TIP BRACKET (F965NF ONLY)