Installation Guide

INSTALLATION INSTRUCTIONS

PREPARE COOKTOP FOR INSTALLATION

WARNING! EXCESSIVE WEIGHT HAZARD: Use two or more people to move and

install the cooktop. Failure to do so can result in back or other injury.

INSTALL COOKTOP

Style 1: Cooktop over under-counter built-in oven

IMPORTANT!: Clamping brackets should not be used.

1. Using 2 or more people, place the cooktop right side up into the cutout.

Decide on the final location for the

cooktop. Avoid drilling into or severing

existing wiring during installation.

1. Using 2 or more people, place the

cooktop upside down on a covered

surface using the foam end posts

from the packaging. Make sure that

the knobs are not resting on the

foam.

2. Remove foam strip roll from the

package containing literature.

Remove the strip at a time and

apply foam strip adhesive-side

down around bottom of the cooktop

glass.

A.) Cooktop base

B.) 1/16" x 3/16" (0.2 x 0.5 cm) Foam strip

C.) Cooktop

NOTE: The foam strip helps avoid damage

to the underside of the cooktop glass from

debris and helps the cooktop sit flat on

uneven counters.

A.) Cooktop base bottom / B.) Clamping screw /

C.) Clamping bracket

NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the

countertop. If repositioning is needed, lift the entire cooktop up from the cutout to avoid

scratching the countertop.

TRADITIONAL KNOB MODELS

Style 2: Cooktop over cabinets

1. Determine whether your cabinet

construction provides clearance

for installing clamping brackets

at cooktop base ends.

2. The clamping brackets must be

installed after the cooktop is

placed into the cutout. Complete

the following steps for the

option.