Owner Manual

18 19
WARNING
• Do not over load your wine cellar to facilitate air circulation.
• Do not stack more than 1.5 rows of standard 0.75L bottles per shelves to
facilitate air circulation
• Avoid obstructing the internal fans (located inside on the back panel of the
wine cellar).
• Do not slide the shelves outwards beyond the fixed position to prevent the
bottles from falling.
• Do not pull out more than one loaded shelf at a time as this may cause the
wine cellar to tilt forward.
• Do not cover the wooden shelves with alloy foil or other materials, as it will
obstruct air circulation.
• Do not move your wine cellar while it is loaded with wines. This might distort
the body of the wine cellar and cause back injury.
Types Of Regulation
Please note that depending on the loading and settings chosen it takes about 24
hours for the wine cellar to see the temperature stabilizing.
During this time LED seems to move erratically in particular,It is normal and
this process occurs whenever the setting is modified and/or whenever a large
amount of bottles are added to the cellar.
Temperature Settings:
• The LED displays by default the actual internal air temperature.
• The temperature of the power, before all Settings will be resumed after the
electricity to power the preset temperature
• The electrical board of all models comes with memory function.
• It is important to understand that there is a difference between the air
temperature inside the wine cellar and the actual temperature of the wine.
• You will need to wait approximately 12 hours before noticing the effects of
temperature adjustment due to the critical mass within a full wine cellar.
Once the temperature is set, it is strongly advised not to toy with it or adjust
frequently. The thermostat will maintain the temperature inside the wine cellar
within a +/- (2.5ºC / 36.5°F) range. But the thermal inertia of the wine and the
glass is such that within this temperature range, the actual temperature of the
wine will only fluctuate ( 0.5ºC to 1ºC )/(33 to 34°F)
WINDOW DISPLAY BOARD OPERATING INSTRUCTION:
From left to right:
1- Energy Saving Mode
Press the button for 3 seconds to enter energy-saving mode, press to exit out of
energy-saving mode
2- ON/OFF the power button:
In the standby mode (unit is off but plugged in): press and hold this button for
3 seconds and the wine cooler is turned on. To power off: press and hold the
button and observe the countdown on Window 4 until the unit is powered off.
3- Lamp button:
Press the button to turn the lights on/off while the unit is powered on
4 - Set Temperature: Displays the setting temperature
5 -Actual Temperature: Displays the actual temperature
6- Temperature setting up button :
Each time this button is pressed the set temperature will increase 1 degree.
7- Temperature setting down button :
Each time this button is pressed the set temperature will decrease 1 degree.
8- C/F display conversion function keys:
Set the conversion degrees Celsius / Fahrenheit display, each press this button,
the display window will be into degrees Celsius or Fahrenheit.