Use and Care Manual

CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR
PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY
PARTS FOR INSTALLING, CLEANING OR SERVICING.
Step 1:
Place the range hood on the wall and mark
the position where you want to install. A
height of 24” to 36” is recommended for
optimal performance. Install at the height
appropriate to your ceiling. Make sure the
chimney can still reach the ceiling. If your
ceiling or preference requires installation to
be a few inches higher or lower than 24-36"
you may do so without major loss of
performance.
Step 2:
Step 3:
Find the exhaust pipe, attach it to the top air
outlet with HVAC foil tape (not included).
Make sure it is connected tightly to the air
outlet.
9
INSTALLATION PROCEDURES
0.50"
9.1"
14.5"
A. Find the 2 mounting holes in the back of the
range hood. Mark their locations at the installation
location with a pencil or marker.
B. Drill 5/16 (8mm) hole at each of the marked
locations.
C. Insert anchors along with screws into each drilled
hole. Firmly tighten the screw into place.
D. Hang your Range Hood into place by aligning
the screws with the two mounting holes in the back
of the range hood.