Use and Care Manual

Step 4:
Step 5:
Insert the inner chimney cover into the outer
chimney cover. Note that the inner chimney
cover must slide into the outer chimney covers
orientation slot.
Attach outer chimney cover to the unit's
motor housing with type M4 screws.
Step 6:
A. Extend the inner chimney cover to the
height at which it will touch the ceiling. Using a
pencil, place a small mark on each side of the
chimney cover which is level with the screw holes
of the chimney. Now slide the inner chimney
cover down.
D. Drill 5/16" (8 mm) hole at each of the marked
locations.
B. Using a pencil, draw a straight line
connecting the two marks you made in Step 5 A.
C. Align the middle of the chimney bracket with
the drawn line and make a mark where each
screw hole in your wall will need to be drilled for
the mounting of the bracket .
Extend the exhaust pipe to the vent-pipe of your
building or to outside. For optimal performance
try to have the least amount of bending
possible.
E. Insert anchors into each drilled hole.
F. Align chimney bracket with the drilled holes
and firmly screw it into place.
10