Installation Guide

SURFACE BURNER OPERATION
 
To activate the electric ignition, simply turn
the control knob counter-clockwise to
maximum power(*position).Press the knob
to start the flow of gas and the ignition spark.
The spark will released at the metal tip of
the white ceramic pin located on the side of
the burner. Once the flame is on , release
the control knob gently.
If the flame turns off, repeat the above
procedure.
ATTENTION: do not ignite burners if the
black burner cap is not installed or not
centred. The flame will be irregular.
M 
Manual ignition is always possible even
when the power is cut off or in the event of
power failure. Turn the control knob
counter-clockwise to the MAXIMUM
position. Light the flame with a kitchen
lighter or with a mach.
23