Installation Guide

1) Unscrew the regulator cap with the wrench.
(See Figure 15)
2) This is how the retainer pin looks for
Natural Gas usage. (See Figure 16)
3) Remove the r
etainer pin. (See Figure 17)
4) Reverse the r
etainer pin and put back into
the regulator cap. This is how the regulator
pin looks for LP gas usage. (See Figure 18)
5) Screw the regulator cap back into the
regulator and re-attach the regulator to the
nipple and flare union. (See Figures 12 and
19)
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
27