Installation Guide

■ Gas valve - The valve is not open.
Make sure the valve is completely open.
■ Gas pipe - There may be air in the gas pipe.
Ignite repeatedly until flame catches.
■ Burner cap
− The burner cap is not placed correctly.
o Replace the burner cap.
− Some holes in the lid are stocked.
o Clean the holes of the lid.
■ Spark pin - The spark pin is wet or contaminated by the food.
Clean and dry the spark pin..
■ Gas connecting pipes - The gas connecting pipes are stocked or squashed.
Contact a qualified technician. Adjust or change the connecting pipes.
THE FLAME GOES OUT DURING OPERATION
■ Thermocouple
− The safety device is contaminated.
o Clean the thermocouple.
− The flame is so little that it can’t touch the thermocouple
o Adjust the flame a little bigger. See the “Proper Burner Adjustments” section.
STRAN
GE SMELL
■ Gas leaking -
Contact a qualified technician
− The gas supply pipe
is old and broken.
o The main burner is not lit.
− Change the gas supply pipe.
o Ignite again after there is no strange smell.
50