Installation Manual

2. Place the bracket so that the back of the bracket is against the rear wall

and the side edge of the bracket is 3/8" to 1/2" from the adjacent cabinet.

NOTE: If there is no adjacent cabinet, place the bracket so that the edge of

the bracket is 3/8" to 1/2" in from the range side panel. If the countertop

overhangs the cabinet, offset the bracket from the cabinet by the depth of

the overhang plus an additional 3/8" to 1/2".

3. Using the anti-tip bracket as a template, mark the two holes for either a

Floor Wood, Floor Concrete, or Wall installation, as shown.

4. Drill two pilot holes where marked. Follow the instructions specific to your

construction.

NOTE: A nail or awl may be used to create a pilot hole, if a drill is not

available. For concrete construction 1/4" x 1 ½" Lag Bolts and 1/2" O.D.

Sleeve Anchors are required.

Wood

• Floor - Drill a 1/8" pilot hole, as shown.

NOTE: Contact a qualified floor covering installer for the best procedure

for drilling mounting holes through your type of floor covering.

• Wall - Drill an angled 1/8" pilot hole, as shown.

Concrete

• Drill the size hole recommended for the anchors into the concrete at the

center of the holes identified as Floor Concrete or Wall.

Distance from Adjacent Cabinet

(3/8" to 1/2" [0.95 cm to 1.27 cm])

Wall Holes

Concrete Floor Holes

Wood Floor Holes

Rear Range Foot

Wall

Anti-tip

Bracket

Floor