Installation Guide

21
4.Installing Converter /
Charger
When selecting the installation location, observe the following
instructions:
y The battery charger can be installed horizontally or vertically.
y Do not install the charger in following situations:
 In wet environments
 In dusty environments
 In the vicinity of combustible materials
 In areas where there is a danger of explosions
y The place of installation must be well ventilated. A ventilation
system must be available for installations in small, enclosed
space. The clearance around the device must be at least
25cm.
y The air inlet on the underside and the air outlet on the back of
the device must remain clear.
y For ambient temperatures higher than 40
(such as in
engine or heating compartments, or direct sunlight), the heat
from the charger under load can lead to reduced output.
y The charger must be installed on a level and sufficiently
sturdy surface.
y Do not install the charger in the same area as the batteries.
y Do not install the charger above batteries, because they can
emit corrosive sulphur fumes that will damage the device.