Installation Manual

17
3. Introduction
WARNING!
LCM port is for remote control connection only.
Please make sure the connection is correct. (CAN cable to CAN1 / CAN2
port , Remote cable to LCM port)
If CAN cable is connected to LCM port, or vice versa, the inverter will be
damaged.
3-13. LCM Port
Connection for LCD remote control panel, you can set and display the SD-series
operation status.
Figure 10. LCM port
Figure 11. LCM cable
LCD Remote Control Panel
SD Series
PIN Num.
Signal Description
PIN Num.
1
CANH
1
2
CANL
2
3
PON
3
4
VCC-
4
5
VCC+
5
6
DIS
6
7
5VS-
7
8
5VS+
8
Table 11. PIN number and signal description for LCD remote control
Note
The cables should be as short as possible (less than 32.8 feet / 10 meters) so
that they can handle the signal.