SE350 User Manual

19
3-2-4. Chassis ground 
Must be connected to earth ground prior to making any other
connections to the equipment.
3-3. Maintenance
Make sure that the fan vents are not blocked.
Use a vacuum cleaner to remove any dust from the fan area
When cleaning the case or front panel, use a soft, dry cloth, only. If
the case or front panel is very dirty, use a neutral, non-abrasive
detergent. Do not use alcohol or ammonia based solutions.
Regular service, and relocation of the inverter, should be performed
by a qualified service technician. Avoid spilling liquid on the inverter.
3-4. Inverter Installation and Operation
Before installing the inverter, make sure the main switch must be
“OFF”.
STEP 1.
Connect the DC cable, then connect
the DC cable to battery.
(Make sure the polarity)
STEP 2.
Dip switch setting for AC output
voltage, frequency, and saving
mode. (Refer to 3-1-4.)
STEP 3.
Connect the AC cable.
Figure 10. Installation step 1
Figure 11. Installation step 2
Figure 12. Installation step 3