SE350 User Manual

20
EN
STEP 4.
Power ON.
The buzzer will send
out “Beep” sounds at
the moment the inverter
will do self-diagnosis,
then the power status
LED indicators will also
appear in various colors. Finally the buzzer will sound another “Beep”
and the power status LED indicators will turn to solid “Green” color
(normal state), means the inverter is now ready to work.
Note:
1. If there is several loads used, turn them on separately after the
inverter has been “ON” in order to prevent the OVP present
caused by the surge power.
2. Set power inverter switch to the ON position and turn the test
load on. The inverter should supply power to the load. If you plan
to accurately measure the true output r.m.s. voltage of inverter, a
meter such as FLUKE 45 BECKMAN 4410 or TRIPLETT 4200
must be used.
Figure 13. Installation step 4