Specifications

87D0058
31
SB50HB Series Woodburning Fireplace


Beware of burning certain material in your fireplace. Among these are plastics, poison ivy twigs
and stems, and chemically treated woods such as discarded poles and railroad ties. These not only
create air pollution, but can induce extreme irritation for some individuals.
Use hemlock, spruce, juniper and other resinous woods with caution. They contain moisture pockets
which, upon heating, “pop” with considerable vigor.
Always use a fire screen. And always “bank” a fire, or at least push all unburned fuel to the rear of
the grate before leaving a fire unattended. Do not use this fireplace as an incinerator.
Because the termination of the chimney above the roof is exposed to wind and cold and the pressure
changes these and other environmental conditions may cause, a sufficient chimney draft may be
hard to establish at times. At other times the draft may be sufficiently disrupted to cause smoke to
spill from the fireplace opening. If problems with chimney draft occur, help start chimney draft before
you build a fire by holding a piece of burning paper near the flue opening at the top of the firebox
to preheat the chimney. If smoke spills from the fireplace opening after the fire is burning, open a
window on the up wind side of the house that is far enough away from the fireplace that the wind
will not blow across the fireplace opening, push the burning wood as near the back of the fireplace
as possible, and if the fireplace is equipped with glass doors, close them.
DO NOT LEAVE CHILDREN OR PHYSICALLY OR MENTALLY HANDICAPPED, OR SENILE
PERSONS ALONE WITH A BURNING FIREPLACE.
You’ll need a minimum of three logs, preferably four, to make a good fire. Add kindling and new
logs as needed to rekindle a dying fire. New logs should be added at the rear grate after raking the
coals toward the front. . Overfire conditions may be created by large
amounts of kindling, building scraps, or other improper fuels.
Ashes, important because they form a bed of glowing coals, should only be left to accumulate within
an inch or two of the bottom of the grate. Excess ashes can be used to check a flaming fire; or to
“bank” your fire, cover the logs with ashes. A “banked” fire will hold glowing coals for 8-10 hours,
thereby saving a fire for later use.

Compared to fossil fuels, a full cord of dry hickory weighs about two tons and is approximately
equal in heating value to a ton of hard coal. On a pound basis, heavy hardwoods have about half
the heating value of coal. The tabulation shows the relative densities and heat values of a variety of
dry woods. Varieties at the top of the list (Dogwood) burn longer and those near the bottom (White
Pine) ignite and burn quicker. A combination of both light and heavy wood is desired.
  
Ash .57-.61 81-8
Southern Pine .51-.60 73-81
Elm .50-.59 71-80
Cherry .50-.5 70
Douglas Fir .45-.51 64-69
Spruce .41-.44 59
Redwood .33-.40 47-54
White Pine .35-.37 50
  
Dogwood .70-.79 100-107
Hickory .70-.74 100
Oak .60-.73 86-99
Black Locust .69-.70 95-98
Beech .64-.66 89-91
Hard Maple .58-.65 83-88
Birch .55-.64 79-86
Apple .58-.6 83-84