Technical data

Chapter 3 Installation
13
AB
Cover I
CDE
Cover II
Figure 3-7 Sketch of external wiring
Two ways of routing are available as follows:
(1) Routing from square conduit areas at the bottom:
Detach the screws from the bottom covers with a
cross-shaped screwdriver, remove the two covers and
connect cables through the square conduit areas.
(2) Routing from round holes on the bottom cover:
(a) Remove the cover screws, put the screws aside,
and then take off the two covers.
(b) Mark all the holes on cover I and II as shown in
Figure 3-7 for the conduits. Two conduits for DC
cables，one for the communication cables and one