Technical data

Chapter 6 Human Machine Interface
55
6.3.6 System setup
Move the cursor to “4 Setting” in the main interface.
Press ENTER to set the current system parameters, as
shown in Figure 6-10. There are 6 submenus in “4 Setting” :
“1 ON/OFF”, “2 Language”, “3 Buzzer”, “4 SysTime”, “5
Commun” and “6 OtherCmd”.
(1) The inverter can be started and shut down with “1
ON/OFF” menu. Move the cursor to “ON” and press ENTER,
“ON State” will then be indicated at the bottom of LCD
screen ; move the cursor to “OFF” and press ENTER, then
“OFF State” will be indicated as well. The inverter will stand
by instead of working normally if the startup conditions are
not satisfied even “ON” is selected. The inverter will be shut
down immediately if “OFF” is selected in any cases.
(2) Two languages, i.e. English and Chinese are
available in “2 Language” menu.
(3) Key beep and fault beep can be set mute/unmute in
“3 Buzzer” menu. “Key beep” and “Alarm beep” can be
shifted by pressing PAGEUP and PAGEDOWN. Shift
between “Enable” and “Disable” by pressing Left and Right if
the cursor is on the “Key beep”. Complete the setup by
pressing ENTER. Similarly, the fault beep can be set up as
well.
(4) Set up the system date and time with “4 SysTime”
menu. (These parameters are of critical importance and will
be used in history information). Select year, month, day, hour
and minute by pressing Page Up/Page Down, and set up the