Installation Guide
INSTALLATION PROCEDURE / STEP 2
2
Measure opening on bottom and cut bottom track (2) 1/8" shorter than opening.
- 4 -
INSTALLATION PROCEDURE / STEP 3 & STEP 4
3
Place wall jamb down over bottom track so that the back of the jamb is between the bottom track
and the wall. Using a level to ensure jamb is plumb, mark hole locations. Remove jamb and drill
holes about 1 1/2" deep at each of the marked locations.
NOTE: When drilling into ceramic, glass or stone use a 1/4" (6mm) MASONRY drill bit.
NOTE: When installing on fiberglass or acrylic use a 1/8" (3 mm) drill bit
and discard the wall plugs.When installing on fiberglass or acrylic the side
jambs may need to be filed at the bottom to fit the contour of the unit.
Repeat Step 3 on the other side.
4