Instructions / Assembly

INSTALLATION PROCEDURE / STEP 5

- 8 -

INSTALL BACK CENTER WALL PANEL

Important Note: The arrows on the label on the back of each panel indicate the TOP of the Panel.

1. Locate the panel labeled (3) Second Panel and lay it down on a ﬂat surface.

2. Based on your measurements from Step 1 (Measuring) trim the height, if necessary, and make any

required plumbing cut-outs according to the instructions in Step 2 (Cutting).

3. Apply the double-sided tape and construction adhesive as explained in Step 3.

4. Peel o back of double-sided tape from the back of the panel. Position the panel at an angle of

approximately 45 degrees, and carefully push the tongue edge into the groove in the trailing

edge of the (3) First Panel. Move the panel gently while exerting forward pressure and carefully

push it toward the back wall.

Important Note: Great care must be taken when installing this panel. The watertight seal depends

on the tongue being ﬁrmly inserted into the groove before the panel is pushed back into position

and height alignment cannot be adjusted once the panel clicks into place.

5. Press against the wall smoothing out any air bubbles along the entire area and then lightly tap

on wall panel with a rubber mallet from top to bottom to ensure it is tightly connected to the wall.