PENDANT PROGRAM DRAWINGS IN THIS MANUAL ARE REPRESENTATIVE ONLY ATTACH YOUR RECEIPT HERE Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-486-4892.
PACKAGE CONTENTS a a. fixture. 1 piece b b. mounting strap (pre-attached to fixture). 1 piece c c. mounting strap screw (pre-attached to mounting strap). 2 pieces d. hardware pack d OR a. fixture. 1 piece a b b. socket ring (pre-attached to fixture). 1 piece c. mounting strap/plate (pre-attached to fixture). 1 piece -OR- c c d. decorative nut (pre-attached to mounting strap/plate). 2 pieces d d e. shade. 1 piece f f. hardware pack e SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS.
SAFETY INFORMATION • DO NOT connect the bare or green insulation fixture ground wire to the black (HOT) current-carrying wire or the white neutral house wire. Connection of the bare or green fixture ground wire to the black or white house wires may cause metal parts of the fixture to carry electrical currents. Under this condition anyone coming in contact with the fixture will receive electrical shock, which could cause serious injury or death.
ASSEMBLY INSTRUCTIONS 1. Turn off circuit breakers and wall switch to the fixture supply line leads. (Fig. 1) 1 DANGER: Failure to disconnect power supply prior to installation may result in serious injury or death. 2. Remove existing fixture and disconnect all electrical wiring. (Fig. 2) ON ON OFF OFF 2 3. Unwrap bare wire from the other two wires in the fixture canopy. Remove mounting strap from the fixture by removing mounting strap screws from the edges of the fixture. (Fig.
ASSEMBLY INSTRUCTIONS 4. Attach mounting strap to outlet box using the existing screws and washers provided with the outlet box. (Fig. 4A or Fig. 4B) 4A Make sure the outlet box can support 35 lbs. hanging weight. Use metal outlet box; plastic outlet boxes are not recommended. NOTE: For mounting strap shown in 4B, adjust fixture screws to proper length by screwing fixture screws completely into mounting strap.
ASSEMBLY INSTRUCTIONS 6. Prepare wire by stripping 3/4 in. of insulation from wire ends using wire strippers. Tie wire into a knot. (Fig. 6A) 6A Connect one of the wires from the fixture to WHITE wire from outlet box using existing wire connector or wire connector provided. Connect the other wire from the fixture to BLACK wire from outlet box using existing wire connector or wire connector provided.
ASSEMBLY INSTRUCTIONS 8. Carefully arrange excess wiring and wire connectors within canopy. Outlet Box 8A Mounting Strap Align holes in edge of fixture canopy with screw holes at ends of mounting strap. Secure fixture with mounting strap screws that were removed in Step 3A on page 4. (Fig. 8A) Mounting Strap Screw 8B ----- OR -----Align holes in fixture canopy with fixture screws on mounting strap and push up.
CARE AND MAINTENANCE Shut off main power supply. Wipe with soft cloth or use window cleaner. Do not use an abrasive cleaner. TROUBLESHOOTING Warning: Before beginning work, shut off the power supply to avoid electrical shock. If you have any questions regarding the product please call customer service at 1-800-486-4892. PROBLEM Bulb will not light. POSSIBLE CAUSE 1. Bulb is burned out. 2. Power is OFF. 3. Faulty connection. CORRECTIVE ACTION 1. Replace light bulb. 2. Make sure power supply is ON. 3.
JEREMIAH LIGHTING LIMITED WARRANTY Jeremiah Lighting, a division of Litex Industries, (hereinafter known as “the Distributor”) warrants all of its Products to be free from defects in material and workmanship, subject to certain conditions and exclusions, for the period of one (1) year from the date the Product was shipped to the original end use purchaser.
