Installation Guide

page 7
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and push
up. Twist canopy to lock. Re-insert screw that was removed,
and then tighten both screws securely. Slide canopy cover
up to canopy, aligning rounded part of slotted holes in
canopy cover with screw heads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it stops.
hanging bracket
screw
screw
canopy cover
canopy
This fan can be used with either 3 or 6 blades.
Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 18 blade attachment screws and washers
and 18 decorative nuts in hardware packs. Place
blade arm on TOPSIDE of blade, aligning holes in
blade arm with holes in blade as shown. [Be sure to
note label on blade indicating THIS SIDE UP and
turn blade so that label faces up.] With fingers, insert
3 blade attachment screws (along with washers)
from the TOPSIDE of blade and 3 decorative nuts
from UNDERSIDE of blade, making sure to
completely insert each screw so that the blade arm
can be attached correctly. Repeat procedure for
remaining blades. Securely tighten screws with
Phillips screwdriver.
Locate blade arm screws and lock washers in
hardware packs. Align blade arm holes with motor
screw holes and attach blade arm with lock
washers and blade arm screws. Before securing
screws permanently, repeat this procedure with
remaining blade arms. Secure all screws.
Note: Tighten blade arm screws twice a year.
blade arm
screws
lock washers
blade attachment
screws and washers
motor housing
blade arm
blade
decorative nuts