Installation Guide

ManualsBrandsCraftmade ManualsCeiling FansCraftmade Metro 44" - 56" 5 Blade Ceiling Fan - Requires Blade Selection

BETTER BY DESIGN

Tripod Ceiling Fans

Installation Instructions

Models: CT52, D52, FR52,

ME52 & OL52

ME52

FR52 OL52D52CT52

P. O. Box 1037

650 S. Royal Lane, Suite 100

Coppell, TX 75019 EE.UU.

(800) 486- 4892

8:00 a 5:00 CST (Hora local central)

Número de fax sin cargo: (877) 304-1728

Correo electrónico: customerservice@craftmade.com

www. craftmade.com

MEJOR DISEÑO

UNE CONCEPTION EXCEPTIONNELLE

P. O. Box 1037

650 S. Royal Lane, Suite 100

Coppell, TX 75019 EE.UU.

de 8 heures à 17 heures (Heure standard du centre)

Numéro de télécopieur gratuit : (877) 304-1728

Email: customerservice@craftmade.com

www. craftmade.com

P.O. Box 1037

650 S. Royal Lane, Suite 100

Coppell, TX 75019

(800) 486-4892

8:00 to 5:00 CST (Central Standard Time)

Toll Free Fax: (877) 304-1728

email: customerservice@craftmade.com

www.craftmade.com

BETTER BY DESIGN

Summary of content (8 pages)

PAGE 1
Tripod Ceiling Fans ® BETTER BY DESIGN P.O. Box 1037 650 S. Royal Lane, Suite 100 Coppell, TX 75019 (800) 486-4892 8:00 to 5:00 CST (Central Standard Time) Toll Free Fax: (877) 304-1728 email: customerservice@craftmade.com www.craftmade.com ® MEJOR DISEÑO P. O. Box 1037 650 S. Royal Lane, Suite 100 Coppell, TX 75019 EE.UU. ME52 (800) 486- 4892 8:00 a 5:00 CST (Hora local central) Número de fax sin cargo: (877) 304-1728 Correo electrónico: customerservice@craftmade.com www. craftmade.
PAGE 2
Read and Save These Safety Precautions 1. Turn off electricity at main switch before wiring or servicing fan in order to avoid possible electrical shock. 2. All wiring must be in accordance with the National Electric Code (ANSI/NFPA 70-1999) and local electrical codes. Electrical installation should be performed by a qualified licensed electrician. 3.
PAGE 3
Preparation Important: When using an existing outlet box, be sure the box is securely attached to the building structure and can support the full weight of the fan. Failure to do so can result in serious injury or death. 1 Step 1 4 Step 4 Prior to securing mounting bracket, screw "J" hook (S10) into ceiling outlet box as a secondary support means. Secure mounting bracket (#1) to the outlet box (A) by tightening bracket screws & washers (S3) as shown.
PAGE 4
6 7 Step 6 Insert wires, including steel cable, from top of support rod (#7) through hole "A" in bottom of "support arm distributor" (#8). Insert ends of remaining two rods into holes "B" and "C" in bottom of distributor. Place wires through hex nut and tighten nut securely onto support rod. Use hex nuts to secure remaining two rods into place. Insert wires through hole "D" and pull through top of downrod section of distributor.
PAGE 5
9 11 Step 9 Thread steel cable through cable clasp (S13). Loop wire over and thread back through cable clasp, making sure loop is large enough to attach on to "J hook (S10) in outlet box. Tighten screw securely to ensure that loop does not come loose. 10 Cable Clasp (S13) Step 10 For added security, attach safety cable from fan unit to "J" hook (S10) in outlet box. Secure by looping zip tie (S11) through safety cable and "J" hook. Tighten zip tie securely. Lift fan onto the mounting bracket (#1).
PAGE 6
12 14 Step 12 Attach canopy (#3) to the mounting bracket by placing screws (S2) into slot in canopy. Twist clockwise to lock into place. Tighten screws firmly. Ceiling Canopy (3) Screws (S2) Step 14 5 Blade Installation Remove rubber cushions, saving motor screws for blade installation. Using motor screws (S5) provided, line up holes from the blade arm with the holes in the motor housing. Tighten screws securely.
PAGE 7
16 Operation Instructions 1. The sequence of operation for the motor pull/chain switch is OFF-HI-MED-LOW. 2. Push the slide switch RIGHT for FORWARD, and LEFT for REVERSE action of the blades. 3. The pull chain switch for the uplights and side body lighting in the body of the fan is two positions - ON/OFF. 4. The Fresco (FR52) and Constantina (CT52) has a four-way switch: OFF-UPLIGHTS-SIDE BODY-BOTH.
PAGE 8
17 Electrical Connections Electrical Connections Continued… Connect black and blue (if provided) fan wires to black outlet wire. Connect white fan wire to white outlet wire and green grounding lead wire from the grounding conductor to the supply circuit (see figure A). Use wire connectors provided with your fan. No loose strands or loose connections should be present.